![]() Drill through the previously-made markings and make sure the drilled holes are large enough to accommodate the wall anchors you are using.Install a power drill with the drill bit.The size of the drill bit should be at least 0.32-centimeter smaller than the wall anchor. Use a masonry drill bit to drill pilot holes through the wall.Step 6: Drill Your Pilot Holes Into The Wall If you think your TV size is more than the average ones, the anchor capacity should be the combined weight of the TV, mount and an extra 20% on top of the total result for safety.Choose a plaster anchor that can carry at least 150 pounds of weight for average TV size.Keep in mind, most mounts come with 4/5 holes and you need to ensure all the screw holes line up with the nearest studs. Hold the mount pressed against the wall and look for holes.Make sure the bottom and top edges of the mount are parallel with the floor.To make your task easier, we recommend using a carpenter’s level (A tool that’s used to indicate if the surface is parallel/perpendicular to earth). To remember the location properly, you can use a painter’s tape for that purpose. Once the finder beeps, mark the location of that stud and try finding the next one.Use a stud finder to locate the studs by holding the finder flat on the wall and activating the device.Make sure the spot has a power outlet nearby. ![]() The larger the TV is, the higher it should be positioned to offer a good viewing angle. You should position the TV at eye level. ![]() What To Do When The Stud Finders Don’t Work? However, if your TV is already positioned in a perfect height that doesn’t need to be altered, then a fixed wall mount is a more suitable option for you. You can even have a TV that comes down as much as 20-inch away from its original place using the tilting mechanism. Suppose, you want to see the TV while sitting on the couch as well as don’t want to miss your favorite show while eating in the dining room either.But your TV can’t be placed at 2 places at once.Īpparently, if you install a tilting TV mount, it will be like having a TV in 2 places at the same time! Got all the things you need in one place?īefore we start hanging the TV on the wall, let’s go over some factors that you need to consider- Do You Want The Mount To Be Flexible?ĭepending on whether you want the mount to be flexible or not, there are different types of mounts available out there. Usually, M8 bolts are best suited for this purpose. The bolts help tighten the mounting gear and make the whole structure a lot stronger. Most of the TV mounting plates come with some bolts to hook them up. For this task, we recommend using the Phillips screwdriver to get the desired result. There are different types of screwdrivers available on the market including slotted, Philips, Torx, Hex, Robertson etc. ![]() To mount the anchor properly, you need a screwdriver for this project. ScrewdriverĪ screwdriver is basically a hand-held tool to turn the screws with its slotted head. ![]() However, make sure the bits are at least 1/8-inch smaller than the plaster anchor you are using for mounting the TV. You will also need drill bits for this purpose. Drill MachineĪ power drill machine is essential for this project in order to make round holes and drive fasteners into the wood studs. Typically speaking, the anchor should be heavy-duty so that it can bear at least 150 pounds of weight. That’s when plaster anchor and anchoring screws come into play!įor plaster walls, you need to choose anchors that are specifically designed for that. In that case, it becomes difficult to find a perfect spot to hang your TV. Sometimes walls don’t have any studs behind them. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |